Adjust Water Level In Kohler Toilet Tank

Pull it toward the tip of the tube outward to reduce the level of water.

Adjust water level in kohler toilet tank. If you hear water run use the adjustment screw at the inner end of the rod to raise the water level in the tank. Now carefully watch the water level in the tank. Turn the adjustment screw counter clockwise to raise the water level. Kohler toilets like all others have a float on the inside.

If you find it is higher or lower than the ideal water level then you have to adjust it. Then turn off the water supply to the toilet by rotating the knob on the wall behind the toilet clockwise as far as it will go. Adjusting the float may be necessary to change water levels in the toilet. The rim feed hose directs water into the toilet bowl when the tank is refilling.

If it is not installed into the flush valve the water level in the toilet bowl will be low. Use the following procedure to adjust the wa ter level in the tank to the line on the flush valve overflow tube. To correct low water level in your toilet bowl ensure the rim feed hose in the toilet tank is connected to the flush valve. Water rising inside the toilet lifts up on the float.

Make sure you rotate it till the end and there is no chance of refilling the tank. Then the steps below to adjust the water level in your tank. Since the height of the float determines the water level turn the screw on top of the fill valve 1 full. Turn off the external water supply that is located on the wall.

Turn the vertical adjuster screw at the top of the valve where the rod connects. Once the water is off check the float which is a plastic ball attached to a long arm at the top of the fill valve. Just rotate it clockwise to stop the water supply. Push the ballcock back a little to increase the flow and height of the water.

Re adjusting the water flow into the tank should resolve any issues with low water levels after flushing. The float controls the flow of water coming into the toilet after a flush. To lower the water level turn the screw clock wise. The water level is raised or lowered by adjusting the float on the fill valve.

Kohler toilets have a water level indicator located on the flush valve or on the tank wall. Now flush the toilet and wait for it to be emptied. Use both actions clockwise to increase the water level and counterclockwise to reduce it. Tank water level adjustment.

Turn on the water supply to the toilet. Follow the steps below to connect the rim feed hose. Do not try to put it roughly on the floor.